You must have simple understand of your Xterra Door Lock Cylinder that you can find some problem correct in time. The dealer has not been able to fix the problem. My guess is that it probably needs some lube, because if it's in the mid-thirties it will unlock to the point that when I pull the handle, it will unlatch to the safety catch, but not fully. The mechanic said Nissan has used the engine block as a ground, since cards today don't have the old-fashioned frame rails. Your Nissan Xterra door lock solenoid actuators are essential to the functionality of your power door locks. But then I had a wierd thing happen when I inadvertently left the driver's door open all night in a pouring rain. Restore your Nissan Xterra to its original level of convenience and fix or replace your broken door lock solenoid actuator right away.
When connecting to an alarm system use all 3 wires and diode isolate. Many of the ways I tried failed, and it takes 2 to 3 days to get a new key made up. My wife started noticing this issue in the middle of the summer on the driver side door. There is a relay that can inhibit the operation of the rear locks. Mathmatically the odds have to be astronomical to have all 4 go out at the same time.
If you think you have seen this actually occur and have witnessed the repair all you have likely really seen is that the initial problem was missed. I think it is a poor ground connection, a connector, or the the Body Control Module. Very often in vehicle electronics the problem lies in connector contact issues. My son and me were shaken and I smelled the gas so I turn the engine, it still running. Elsewhere in this section someone posted a ground solution Maxima that looks good. So now I'm wondering where all the relays are located for the door locks.
As for all four door lock actuators being bad, I would never had believed it until I saw an 05 maxima with the same problem. Our 2004 Murano has the same door actuator problem, both front locks are intermittant to reliably lock and unlock the doors. Let's be serious here, the likelihood of four or five lock motors failing simultaneously is pretty much zero. Trust in the value of the parts you get from carpartsdiscount. Just put everything back in place other than the metal plate and you will never know anything was done. I can unlock it with the key just fine, but the electrics won't unlock it. One part of your Nissan Xterra is the Door Lock Cylinder.
They are independent publications and are not affiliated with or endorsed by or. However, you'll need to keep a phillips screwdriver possibly in the vehicle, incase it's needed to remove speaker covers speaker, etc if installed and hinder the paneling to be removed otherwise. The right rear power window made noise when rolling up and down. Jan 22, 2014 try testing or replaceing the drivers door lock actuator, reprogram ur key fobs and try unlocking and locking ur doors. Other times it won't unlock at all. If is works then it wasn't the problem and should be reinstalled.
I am having the problem on my 05 Murano, the driver door does not lock or unlock with the remote. Pay for only one solenoid and labor. Select Year for Nissan Xterra Door Lock Cylinder. Therefore a single low resistance or shorted lock motor could render all those wired in parallel to appear to be non-functioning. We've got them right here.
If you are interested in advertising a for-profit service,. Posted on Nov 13, 2013 sounds like an intermittent short in the wiring, a good place to start looking is where the loom goes through the door by the hinges, this is a place where the get a lot of wear, start with the drivers door and remove the door panel and check for any obvious chaffs in the wiring, maybe give it a little wiggle. Remember, in this case there's no obvious indication the door isn't locked unless someone walks up and opens it from the outside. So why is it a safety issue? Please let me know if you need further assistance. I pulled the battery cable to attempt a reset of the truck but it continues. Your suggestion to replace the relay that powers the gas cap solenoid makes perfect sense. When your Nissan needs a new replacement Door Lock Solenoid Actuator, there's no need to waste time looking anywhere other than the authority, Car Parts Discount.
It does still act up and seems like it's sticking. If anyone can simply open the door to gain access, carjacking, injury, or even murder is easier. If you cannot physically open it manually you will have to remove the hatch panel from inside the vehicle and investigate further. So how do you find out what problems are occurring? If the doors locked properly this provides a more secure environment for this type of scenario. I'm sure hoping this is something I can do myself and not have to take my beast back to the nearby Nissan dealer. Front driver's side auto door lock works intermittently. I do worry about the behavior of the truck on the road under rain, snow, or ice conditions.
If this dosen't work you can try looking into the seat belt with a flash light and see if you can see anything moving compare with a belt that works properly. Now, out of warranty and its starting to add up quickly. I have had the truck for about 6 months and everything worked like it should until about two weeks ago. This is the part that sends current to locks , power seats and some more thinks. It was kind of chilly and the road have some snow on it. But it's not a big enough of a problem yet to take the panel off the inside of the hatch and fix it. What is strange is the problem appeared on the 3 doors all at once - the odds of all three door lock actuators failing all at once are very bad.